Common problem
Do you really know that there are many points to pay attention to when installing a laser cutting chuck? 1. When installing, inspecting or maintaining the laser cutting chuck, close all power sources to ensure that the operator
2. Do not start the switch before closing to avoid flying out of the workpiece or claws;
3. Before daily work, the operator should carefully check whether the fastening screws of the jaws are tight and whether the air source pressure is normal. Please use clean and stable compressed air. The air pressure is controlled within the range of 0.4~0.9MPa, and the pressure must be selected. The air pipe larger than 1.6MPa is connected to the product, and the air pipe should be far away from heat sources and open flames, otherwise it will affect the use and bring hidden dangers to the production;
4. The laser cutting chuck should be lubricated and maintained at all sliding surfaces and friction surfaces during use. Refueling and maintenance should be carried out in strict accordance with the prompts of each refueling point. Regularly refuel in the oil tank of the triplex and control dripping. speed.
5. When the jaws or rollers of the laser cutting chuck need to be adjusted, a nut seat should be installed on the slider, and the bolt should be used for fine adjustment until it meets the requirements of use. After the adjustment is completed, the trial installation and clamping should be carried out. The slider movement should be flexible and free. Enter the working state;
6. Do not modify the chuck at will, improper modification will damage the chuck and cause it to be unable to use it normally;
7. When the laser cutting chuck is not used for a long time, the workpiece cannot be held on it continuously to prevent the chuck from being deformed and affecting the accuracy;
8. Clean the movable parts 2-3 times a week, maintain the chuck every 60 days, check the wear of the parts, and replace the parts if necessary;
9. Pay attention to the solenoid valve coil voltage when connecting the electrical control part, and connect to a power supply with a suitable voltage to avoid damage to the electrical device.
The above are the things to pay attention to when installing the laser cutting chuck. There are more points to pay attention to. Customers who don’t know can read it carefully or contact us