Industry news
The chuck type intersecting wire cutting machine has a simple structure. When the system calculates, the chuck rotates one circle as the parameter, and it has the correct degree of measurement. Relatively speaking, the roundness of the pipe is also lower. Sometimes the pipe is slightly bent. It can also be cut by adjusting the position of the frame. During operation, it is very important to pay attention to the adjustment of the position of the bracket at any time to maintain the level of the pipe. If this position is not adjusted well, a larger cutting error will occur. In addition, near the chuck chuck chuck chuck area, there will always be a blind area that cannot be cut, which affects the yield of the pipe. Generally, small-diameter pipes with a pipe diameter of not more than 600mm adopt this kind of structure.
Corresponding drive slot and escape slot can be set on the outer chuck, a boss can be set on the outer chuck, and a groove that fits with the boss can be set on the inner chuck. The positioning mechanism can be sleeved on the outer card. Positioning spring on the disc. The hydraulic chuck is arranged at the connecting end of the drill rod of the main shaft, and the reduction transmission mechanism is a first-grade helical gear reduction transmission mechanism, which is compact in structure and can effectively reduce the size and weight of the power head; in a further technical solution, the motor Adopting inclined-axis plunger variable motor, adjust the displacement of the variable motor to achieve stepless speed regulation; power chuck power chuck power chuck power chuck power chuck uses normally closed hydraulic chuck, and is designed with a double-stage sealing structure. The sliding seat can be effectively installed in the dust-proof groove, and the T-block and the claw are installed on the sliding seat with the claw mounting screw. The piston is installed in the chuck body and connected with the wedge sleeve. The back of the chuck body is equipped with air distribution The ring, the gas distribution ring and the chuck body are sealed by a sealing ring, and a pipe joint and a second pipe joint are installed on the upper part of the gas distribution ring.
A chute is provided on the wedge sleeve. The principle of clamping a workpiece in a disc is to use a chuck wrench to rotate any one of the three umbrella teeth on the circumference. Thereby driving the plane thread to rotate and driving the three jaws to move together, playing the role of self-centering and clamping the workpiece; from the mechanical structure, the three umbrella teeth of the chuck chuck chuck have the same function, but after careful In the inspection, the accuracy of the three bevel gears to clamp the workpiece is not the same, and the difference is also large.
Rui Card (Changzhou) Technology Co., Ltd.